
Water Utility · New Bedford, MA
How we built this page: from New Bedford Department of Public Infrastructure's public water system records (detected and not-detected contaminant lists), the federal limits in EPA's drinking water regulations and USGS hardness classes. Records were checked November 2026; the utility's latest annual report has the measured levels.
New Bedford Department of Public Infrastructure supplies surface water to about 95,841 people in New Bedford, Massachusetts. Public records list 6 contaminants detected in its water; a detection is not the same as a violation. For billing or a copy of the annual report, contact the utility directly; for what to do about your own tap, start with a free Local Water Analysis Report.
New Bedford Department of Public Infrastructure at a Glance
| Area served | New Bedford, Massachusetts |
|---|---|
| Population served | 95,841 |
| Water source | Surface water |
| Phone | 508-979-1400 |
| Address | 133 William Street, New Bedford, MA 2740 |
| Contaminants detected | 6 listed in public records |
1. Where Does New Bedford Water Come From?
New Bedford Department of Public Infrastructure delivers surface water to homes and businesses in New Bedford, Massachusetts. It serves about 95,841 people. Every public water system must test its water under the federal Safe Drinking Water Act and publish the results each year in a Consumer Confidence Report.
Read the full results in the New Bedford Department of Public Infrastructure annual water quality report, or see what EPA requires in every report on its Consumer Confidence Report page.

2. What Has New Bedford Department of Public Infrastructure Detected in Its Water?
Public records list 6 contaminants detected in New Bedford Department of Public Infrastructure water. A detection means a test found it at any level. Most results sit below federal limits; the table explains the ones with a limit or a known fix.
| Contaminant | What it is | Federal limit (EPA) | What removes it at home |
|---|---|---|---|
| Total trihalomethanes (TTHMs) | Disinfection byproducts that form when chlorine reacts with natural matter in the water | EPA limit: 80 ppb (running annual average) | A whole-house carbon filter |
| Chloroform and related trihalomethanes | Individual disinfection byproducts counted inside the TTHM total | Counted in the 80 ppb TTHM limit | A whole-house carbon filter |
| Chromium-6 (hexavalent chromium) | A form of chromium from natural deposits and industry | No separate federal limit; total chromium is limited to 100 ppb | Reverse osmosis at the kitchen tap |
| Nitrate | Mostly from fertilizer, septic systems and natural deposits | EPA limit: 10 ppm (as nitrogen) | Reverse osmosis at the kitchen tap |
| Aluminum | Often left over from water treatment chemicals | EPA secondary (non-health) guideline: 0.05 to 0.2 ppm | Reverse osmosis at the kitchen tap |
All 6 detected contaminants
- Bromodichloromethane
- Chloroform
- Chromium (hexavalent)
- Total trihalomethanes (TTHMs)
- Aluminum
- Nitrate
Tested but not detected (67)
- 1,1-Dichloroethane
- 1,2,3-Trichloropropane
- 1,2-Dibromo-3-chloropropane (DBCP)
- 1,3-Butadiene
- 1,4-Dioxane
- 2,4,5-TP (Silvex)
- 2,4-D
- 3-Hydroxycarbofuran
- Alachlor (Lasso)
- Aldicarb
- Aldicarb sulfone
- Aldicarb sulfoxide
- Aldrin
- Antimony
- Arsenic
- Atrazine
- Benzo[a]pyrene
- Beryllium
- Bromochloromethane
- Bromoform
- Bromomethane
- Butachlor
- Cadmium
- Carbaryl
- Carbofuran
- Chlordane
- Chlorodifluoromethane
- Chloromethane
- Cobalt
- Cyanide
- Dalapon
- Di(2-ethylhexyl) adipate
- Di(2-ethylhexyl) phthalate
- Dicamba
- Dieldrin
- Dinoseb
- Endrin
- Ethylene dibromide
- Heptachlor
- Heptachlor epoxide
- Hexachlorobenzene (HCB)
- Hexachlorocyclopentadiene
- Lindane
- Mercury (inorganic)
- Methomyl
- Methoxychlor
- Metolachlor
- Metribuzin
- Molybdenum
- Nitrite
- Oxamyl (Vydate)
- Pentachlorophenol
- Perchlorate
- Perfluorobutane sulfonate (PFBS)
- Perfluoroheptanoic acid (PFHPA)
- Perfluorohexane sulfonate (PFHXS)
- Perfluorononanoic acid (PFNA)
- Perfluorooctane sulfonate (PFOS)
- Perfluorooctanoic acid (PFOA)
- Picloram
- Polychlorinated biphenyls (PCBs)
- Propachlor
- Selenium
- Silver
- Simazine
- Thallium
- Toxaphene

Best Water Treatment for New Bedford Tap Water
- 32K, 40K, 48K or 64K grain sizes
- Uses about 60% less salt than a traditional softener
- IAPMO/NSF certified control valve

- Catalytic carbon for chlorine and chloramine
- Cuts the disinfection byproducts (TTHMs, HAA5) they form
- Treats every tap, shower and appliance

- Bone char plus catalytic carbon
- Reduces fluoride, chlorine and chloramine
- Whole house, made for city water

Prices are the starting price for each system, checked November 2026. Free shipping within the USA on systems (excludes AK, HI and PR).
3. Is New Bedford Tap Water Safe to Drink?
Federal law sets the limits New Bedford Department of Public Infrastructure water has to meet, and each year's water quality report shows the results. Meeting a limit doesn't mean a contaminant is absent. If someone in your home is pregnant, very young, elderly or immune-compromised, ask a doctor whether to filter your drinking water.
Your own tap can differ from the utility average. Lead usually comes from older service lines and home plumbing, not the treatment plant. Run the tap before drinking if water has been sitting, and get a free Local Water Analysis Report for your address.
4. Is New Bedford Water Hard?
Hardness is calcium and magnesium, and it shows up as white crust on faucets, spots on glasses and scale in your water heater. By USGS classes, 61 to 120 mg/L (3.5 to 7 gpg) is moderately hard and over 180 mg/L (10.5 gpg) is very hard. Check the New Bedford Department of Public Infrastructure report for its hardness figure, or test at home with strips.

To stop scale, size a salt-based softener to your hardness and water use. The SoftPro Elite (32,000 to 64,000 grains) uses about 60% less salt than a traditional softener, and most owners install it themselves. Start with the sizing calculator.
Get Your New Bedford Water Report and Softener Size
Not sure what's in your water or what size you need? Enter your address for a free local water analysis report, and our sizing calculator matches a softener to your hardness and household.
Get my free water report5. How to Treat New Bedford Tap Water
There's no single filter for everything, so start from the problem. Hardness needs a softener, chlorine and its byproducts need carbon, and dissolved metals and nitrate in drinking water need reverse osmosis. A pitcher or fridge filter covers one glass at a time, not the whole house.
| What you want to fix | What works | SoftPro option |
|---|---|---|
| Hard water scale and spots | Salt-based ion exchange softener | SoftPro Elite water softener |
| Chlorine taste, TTHMs and HAA5 | Whole-house catalytic carbon | Chlorine+ whole-house filter |
| Fluoride | Bone char plus carbon | Fluoride & Chlorine+ SUPER filter |
| Arsenic, nitrate, chromium-6, lead and PFAS in drinking water | Reverse osmosis at the kitchen tap | Reverse osmosis systems |
6. What SoftPro Customers Say
SoftPro has 10,000+ reviews from more than 100,000 customers. Most install the system themselves, and every system comes with a 6-MONTH money-back guarantee with no restocking fee.
"The soft water is lovely. It has only had to regenerate twice in 30 days unlike my older unit... I like the display showing the usage, flow rate and remaining charge in gallons."
Michael C., verified Loox review, March 2026"No more ugly calcium deposits in bath/shower and around fixtures! I love all the advanced features around regeneration and less salt use, too!"
Jeffrey S., verified Loox review, May 2026

7. How to Contact New Bedford Department of Public Infrastructure
For billing, outages or a copy of the annual report, contact New Bedford Department of Public Infrastructure directly. You can call 508-979-1400, visit 133 William Street, New Bedford, MA 2740 or go to the utility's website.
Frequently Asked Questions
Where does New Bedford Department of Public Infrastructure water come from?
New Bedford Department of Public Infrastructure supplies surface water to New Bedford, Massachusetts.
Does New Bedford Department of Public Infrastructure test its tap water?
Yes. Like every public water system, New Bedford Department of Public Infrastructure must test its water under the federal Safe Drinking Water Act and publish an annual water quality report (Consumer Confidence Report). Ask the utility for the latest report or look for it on its website.
Does New Bedford Department of Public Infrastructure water contain lead?
Water usually leaves the treatment plant without lead. Lead can enter tap water from older service lines, solder and brass fixtures inside homes, especially when water sits in the pipes. Run the tap before drinking if water has been sitting, and ask the utility about lead testing and service line records.
Is New Bedford Department of Public Infrastructure water hard?
Hardness depends on the source and changes over time. The annual water quality report lists hardness, or you can test it at home. If it is above about 7 grains per gallon, a water softener sized to your measured hardness will stop scale and spotting.
How do I get a water report for my New Bedford address?
Use SoftPro's free Local Water Analysis Report, or ask the utility for its latest annual Consumer Confidence Report.
Know Your New Bedford Water. Then Pick Your System.
Get your free local water analysis report first, then match the treatment to what is actually in your water.
Get my free water reportSources (checked November 2026)
- Public water system records for the utilities listed on this page (detected and not-detected contaminant lists)
- EPA National Primary Drinking Water Regulations and Consumer Confidence Reports
- USGS: Hardness of Water
- SoftPro product pages for specs, prices and Loox review counts